Skip to content

Step2.md

Jump to bottom
Yohann edited this page Jun 17, 2021 · 1 revision

Step 2 : Server's PCB

This second step is for soldering everything onto the server's pcb.

  1. Take the server's pcb

server pcb

  1. Take the 3 buttons and solder them

3 buttons

buttons soldered

  1. Take the potentiometer and solder it

potentiometer

potentiometer soldered

  1. Take the NRF24L01 and solder it

take nrf24

solder nrf24

  1. Take the Arduino Nano (solder the leads if needed) and solder it on the pcb

before the leads

after the leads

arduino nano and pcb

arduino nano soldered

  1. Take the 10uF capacitor and solder it (be careful, it's a polarized capacitor and therefore the positive side must match the little + on the pcb)

take cap

solder cap

And you're done with the pcbs ! Now you should have all three pcbs :

all pcbs

Assembly guide

Clone this wiki locally