The defusor has to tell the expert voltage levels between two testpoints. The expert looks up the next voltage to meassure or tell to press a button to defuse the module.
This module consists of:
- 6 testpoints for "meassuring"
- background that show the connection between testpoints
- a voltage display
- a button
- two test leads
The two leads are not used to actually meassure anything. They are just connected to each other. When inserted into testpoints, the mcu will deteremine which testpoints are now connected and display a predetermined voltage on the display.
When the button is pressed the mcu checks if the correct testpoints are connected and that the button was pressed when the voltage display is showing the correct voltage.
If that's the case this modules is successfully disarmed. Otherwise it counts as a failed attempt.
- Print out a conduits background and glue it onto your module
- Drill holes at the black circles for the testpoints
TODO finish build instructions
TODO add arduino sources
TODO add circuit diagram
TODO link to main project