Waiting to heat #711
-
|
Is there a way how I can influence the Wait to Heat time? |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
As of last week, yes! :) You need to install the BrewPi-ESP8266 v15-beta5, but once installed you should be able to update the timings from the controller's web interface. You will not be able to adjust these from within Fermentrack unfortunately, but that functionality will likely come at some point in the future. |
Beta Was this translation helpful? Give feedback.
-
|
What is the url to the web interface of controller?
…On Mon, Mar 20, 2023 at 11:16 AM John ***@***.***> wrote:
As of last week, yes! :)
You need to install the BrewPi-ESP8266 v15-beta5
<https://github.com/thorrak/brewpi-esp8266/releases/tag/v15-beta5>, but
once installed you should be able to update the timings from the
controller's web interface. You will not be able to adjust these from
within Fermentrack unfortunately, but that functionality will likely come
at some point in the future.
—
Reply to this email directly, view it on GitHub
<#711 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AONWDKFKRFVNQNVE73KHVALW5BYDVANCNFSM6AAAAAAWAVEYWQ>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
Assuming you’re running v15 beta 5, it should just be the IP address of the controller (which should be shown at boot) |
Beta Was this translation helpful? Give feedback.
As of last week, yes! :)
You need to install the BrewPi-ESP8266 v15-beta5, but once installed you should be able to update the timings from the controller's web interface. You will not be able to adjust these from within Fermentrack unfortunately, but that functionality will likely come at some point in the future.