KMK Config for that board for RP2040 #1
Replies: 2 comments 1 reply
-
Neat! I'm currently working on the PCB for release 1.0, with some changes to the layout. But it should be easy to adapt. |
Beta Was this translation helpful? Give feedback.
-
Keep in mind that Chrumm still is an unfinished, mostly untested prototype. I don't think it is a good idea to rely on it for work. Especially if you have no experience building keyboards. To temper expectations, the next release will abandon the function row in favor of standard Ctrl and arrow keys at the bottom. This will also reduce cost and print time. The function keys are layered instead, closer to the home position: For hand-wired builds, one can still generate a custom body and firmware, but the PCB will not include a function row. |
Beta Was this translation helpful? Give feedback.
-
Not yet tested on an actual board, just with couple of switches and did few changes to original design.
Also missing settings rotary bit - will work on that after I'll finish with soldering everything
`
Beta Was this translation helpful? Give feedback.
All reactions