Question - How to transfer val3 from USB to the controller?

[Niknu]

Hi there,

I'm not sure how I should transfer the val3 driver to the controller, you are writing as followed:

" There are multiple ways of transferring VAL 3 applications to the controller:

1. Copy the contents of val3 folder onto a USB memory stick (<2GB if using CS8), plugging the stick into the controller and using the teach pendant to copy the folders "

In my case, I have a CS8 controller and the controller can see the USB stick with ros_libs + ros_server.
But when I try to load the ros_server it says something with the incorrect type in SimpleRosMsg on the line 1.

I'm doing it correctly, or?

[pratipo]

same here, not using SRS

i managed to upload both folders using filezilla
you need to plug your controller to the network and check the ip in the control panel -using the pendant-, then use

host:192.168.1.10/usr
username: default
password:
port:

inside /usr there is a folder called /usrapp where you place the 2 folders

controller: cs8c
val: 7.11.2

[gavanderhoorn]

This starts to sound a bit like #27. Could you both take a look?

[Niknu]

I have tried to clone and download zip on Linux and Windows. It doesn't work with the #27 solution,

What I have is :

Controller : cs8
System: s.7.9.1

Below is images of what I assume is needed information

When I see the Event loggers output

[gavanderhoorn]

So both with the .zip as with git clone gives you these errors?

And #27 wasn't really intended to be a solution. It was just a reference to an issue which seems similar.

[gavanderhoorn]

As this seems to be the same -- or a similar enough -- error as in #27, I'd like to suggest we re-open #27 and continue there.

[gavanderhoorn]

I'm going to close this one, we'll continue in #27.