Tronxy XY-2 Pro - UBL not working

[DarkDevX]

Description:
I have updated to the latest version of Marlin for my Tronxy XY-2 Pro. When I run the G29 P1 command on a freshly imaged board, the command stops at point 36/100. This point happens to coincide exactly where the device homes. The probe simply does not move once it moves above point 36 nor deploys.

Config:
XY2_V6_255_NO_TITAN_TMC

Commands:
M502
M500
G28
G29 P1

Configuration.h.log

[orangeworx]

I have not tried using UBL with the tronXY printer (X5SA-Pro in my case) so I'm not certain what differences exist but mine homes at x=0 and y=0. Have you changed homing location or have not enabled homing at 0,0?
I'm also suspecting that you're not using 2.0.x bugfix as the board selection doesn't look the same