printer-20210807_170355.cfg

[include ./conf/main_printer.cfg]
[include ./conf/steppers.cfg]
[include ./conf/extruder.cfg]
[include ./conf/heaters.cfg]
[include ./conf/probe.cfg]
[include ./conf/resonance.cfg]
[include ./conf/fans.cfg]
[include ./conf/leds.cfg]
[include ./conf/klicky.cfg]
[include ./conf/displays.cfg]
[include ./conf/temperature.cfg]
[include ./conf/frame_expansion.cfg]
[include ./conf/nozzle_clean.cfg]
[include ./conf/macros.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 35.776
#*# pid_ki = 1.223
#*# pid_kd = 261.609
#*#
#*# [extruder]
#*# control = pid
#*# pid_kp = 14.085
#*# pid_ki = 0.614
#*# pid_kd = 80.813
#*#
#*# [stepper_z]
#*# position_endstop = 1.210
#*#
#*# [bed_mesh default]
#*# version = 1
#*# points =
#*# 	  -0.100000, -0.060000, -0.045000, -0.022500, -0.050000, -0.062500, -0.077500
#*# 	  -0.067500, -0.042500, -0.025000, -0.020000, -0.037500, -0.045000, -0.070000
#*# 	  -0.070000, -0.030000, -0.020000, -0.012500, -0.030000, -0.037500, -0.060000
#*# 	  -0.055000, -0.017500, -0.007500, 0.000000, -0.017500, -0.037500, -0.057500
#*# 	  -0.052500, -0.020000, -0.002500, 0.002500, -0.010000, -0.025000, -0.042500
#*# 	  -0.045000, -0.012500, -0.015000, 0.000000, 0.000000, -0.030000, -0.047500
#*# 	  -0.072500, -0.032500, -0.017500, -0.002500, -0.007500, -0.022500, -0.047500
#*# tension = 0.2
#*# min_x = 30.0
#*# algo = bicubic
#*# y_count = 7
#*# mesh_y_pps = 2
#*# min_y = 30.0
#*# x_count = 7
#*# max_y = 270.0
#*# mesh_x_pps = 2
#*# max_x = 270.0