Case: need to finalize silkscreen

[jadonk]

We need a reviewed silkscreen/etch with:

• BeagleBoard.org logo
• LED indication (current schematic definition isn't accurate)
• Button labels
• MikroBUS labels

[jadonk]

@GuoqingLing2589 @FionaYu20180326 Do you have any plans to create the silkscreen for the case/enclosure?

[GuoqingLing2589]

Sure, what do you think of the effect of the picture below?

[jadonk]

It looks good. Need to double-check pin positions and align with official mikroBus specification for sockets on both sides. Need to add "beagleconnect" and "freedom" below beagleboard.org.

[GuoqingLing2589]

Okay, got it.

[GuoqingLing2589]

Please see the new rendering.

[jadonk]

@GuoqingLing2589 Please put "BeagleConnect" and "Freedom" on separate lines to make the text bigger. We have a lot of blank space. :-)

[GuoqingLing2589]

So is this okay?

[jadonk]

I'd go ahead and expand "Freedom" to be the full width of the available space. Also, "Connect" in "BeagleConnect" could be a different color.

[GuoqingLing2589]

What about this look?

[jadonk]

• Can you add ® marks to both the BeagleBoard.org logo and "BeagleConnect"?
• Do you have any markings for the RESET and BOOT/USER buttons?
• Do you have a similar set of markings for the backside?
• I think we need some indication of which mikroBUS. On "top", the side with the USB connector, LEDs, buttons, and MSP430, that is mikroBUS 1. On "bottom", the side with the CC1352 and battery connector, that is mikroBUS 2.

[GuoqingLing2589]

• Okey, we will add it.
• We have added silkscreen to the RESET and BOOT/USER buttons.
• for the backside, it have the same silkscreen.
• Okey.
  We will finish it as soon as possible and send you the renderings.

[GuoqingLing2589]

We finished it, but there is a problem that the ® is too small and not obvious if we follow the trademark specification.