Pcode emulator has no execute breakpoint? Doesn't work at all?

[astrelsky]

Am I just supposed to run it until it inevitably crashes? I see you can do read/write breakpoints which is great but not execute? That doesn't make any sense.

I tried using the addBreakpoint in PcodeMachine with an empty string but that just threw an exception.

[astrelsky]

Even better, if provided Methodhandles.publicLookup() you get "publicLookup does not have full privilege access". I have no nested PcodeUseropLibrary so the default public lookup should suffice. It doesn't say what it is attempting to access nor can I find it by searching for part of the error message. The stacktrace only leads to JitPcodeThread.run

[astrelsky]

If I give it MethodHandles.Lookup instead I then get a "DecodePcodeExecutionException: Unknown disassembly error (PC=address from setCounter)" again with no stack trace other than JitPcodeThread.run.

[astrelsky]

I'm just going to go ahead and assume that this isn't actually ready for use yet. It doesn't appear to be usable in its current state.