Question about Flashing Firmware

[M7Fa]

Hello,

First of all, this is an awesome project and I'm really looking forward to building this. I'm working with a breadboard right and have done a few things with Arduino Uno using sketches; so this is my first time flashing the firmware. I bought the Arduino Nano 33 IoT (based on the link from the Arduino Article on how to setup the project -- https://projecthub.arduino.cc/andreockx/capibarazero-a-multifunctional-security-and-hacking-tool-15a318). However, I'm completely unable to get esptool to flash the firmware. Using the Arduino IDE I can upload a sketch (like blink). I have the board in bootloader mode and it's assigned a COM port (Windows). Do, I need a specialized tool to flash the firmware through the SWD pins or do I just have the wrong board?

Thanks,
M7

[andreock]

Hi! Arduino Nano 33 iot is not supporterd, I don't know why article go to Arduino Nano 33 iot link under the Arduino Nano ESP32 component. I will Fix later. The correct board is this one: https://store.arduino.cc/products/nano-esp32-with-headers?queryID=7281fc19441a125e4e3746f134f515f2 Inviato da Proton Mail Android

…

-------- Messaggio originale -------- 01/11/24 18:05, M7Fa ha scritto:

Hello, First of all, this is an awesome project and I'm really looking forward to building this. I'm working with a breadboard right and have done a few things with Arduino Uno using sketches; so this is my first time flashing the firmware. I bought the Arduino Nano 33 IoT (based on the link from the Arduino Article on how to setup the project -- https://projecthub.arduino.cc/andreockx/capibarazero-a-multifunctional-security-and-hacking-tool-15a318). However, I'm completely unable to get esptool to flash the firmware. Using the Arduino IDE I can upload a sketch (like blink). I have the board in bootloader mode and it's assigned a COM port (Windows). Do, I need a specialized tool to flash the firmware through the SWD pins or do I just have the wrong board? Thanks, M7 — Reply to this email directly, [view it on GitHub](#48), or [unsubscribe](https://github.com/notifications/unsubscribe-auth/AGKFZ66R756M2UKUW7U5WODZ6OYGZAVCNFSM6AAAAABRATZTLWVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZXGQYDOMBUGI). You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>